Newest Fortinet NSE7_SDW-7.2 Practice Questions at Zero Cost

Get a glimpse of the real NSE7_SDW-7.2 certification exam challenges with our free Fortinet NSE7_SDW-7.2 practice test questions.

Refer to the exhibit.

q1_NSE7_SDW-7.2

In a dual-hub hub-and-spoke SD-WAN deployment, which is a benefit of disabling the anti-replay setting on the hubs?

AIt instructs the hub to disable the reordering of TCP packets on behalf of the receiver, to improve performance.

BIt instructs the hub to disable TCP sequence number check, which is required for TCP sessions originated from spokes to fail over back and forth between the hubs.

CIt instructs the hub to not check the ESP sequence numbers on IPsec traffic, to improve performance.

DIt instructs the hub to skip content inspection on TCP traffic, to improve performance.

Refer to the exhibit.

q2_NSE7_SDW-7.2

The exhibit shows the details of a session and the index numbers of some relevant interfaces on a FortiGate appliance that supports hardware offloading. Based on the information shown in the exhibits, which two statements about the session are true? (Choose two.)

AThe reply direction of the asymmetric traffic flows from port2 to port3.

BThe auxiliary session can be offloaded to hardware.

CThe original direction of the symmetric traffic flows from port3 to port2.

DThe main session cannot be offloaded to hardware.

Refer to the exhibit.

q3_NSE7_SDW-7.2

The exhibit shows the BGP configuration on the hub in a hub-and-spoke topology. The administrator wants BGP to advertise prefixes from spokes to other spokes over the IPsec overlays, including additional paths. However, when looking at the spoke routing table, the administrator does not see the prefixes from other spokes and the additional paths.

Based on the exhibit, which three settings must the administrator configure inside each BGP neighbor group so spokes can learn other spokes prefixes and their additional paths? (Choose three.)

ASet additional-path to send

BEnable route-reflector-client

CSet advertisement-interval to the number of additional paths to advertise

DSet adv-additional-path to the number of additional paths to advertise

EEnable soft-reconfiguration

Refer to the exhibit.

q4_NSE7_SDW-7.2

Which conclusion about the packet debug flow output is correct?

AThe original traffic exceeded the maximum packets per second of the outgoing interface, and the packet was dropped.

BThe reply traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.

CThe original traffic exceeded the maximum bandwidth of the outgoing interface, and the packet was dropped.

DThe original traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.

Which two statements are true about using SD-WAN to steer local-out traffic? (Choose two.)

AFortiGate does not consider the source address of the packet when matching an SD-WAN rule for local-out traffic.

BBy default, local-out traffic does not use SD-WAN.

CBy default, FortiGate does not check if the selected member has a valid route to the destination.

DYou must configure each local-out feature individually, to use SD-WAN.

Master the Fortinet NSE 7 - SD-WAN 7.2 NSE7_SDW-7.2 exam like never before! You’ve reviewed the free NSE7_SDW-7.2 practice questions, but the actual FCSS in Network Security certification exam demands more. Elevate your preparation with Certsmarket premium FCSS in Network Security NSE7_SDW-7.2 practice exam questions.

Explore Free Fortinet FCSS in Network Security NSE7_SDW-7.2 Practice Questions for Exam Mastery

Our Community

What our students say about us?